Are you looking for Netgear n300 wifi range extender setup ex2700.
Then once go through this article. Because in this article we have discussed
about how to setup Netgear n300 wifi range extender.
How to setup Netgear n300 wifi range extender?
1- You must Install your extender in the same room as the Wi-Fi
router.
2- Then you must check that your internet is active connection and
which must be coming from the main router.
3- Then you have to plug in your router extender at the electrical
outlet and then wait for the at the extender LED is blinking in green colour.
And if it is does not blink then you have to turn on your router
through side panel on and off button, then wait for few minutes then again turn
on your extender.
factory default settings netgear wifi extender n300 device
4- Then you have to Connect your computer with the extender via
ethernet cable.
5- Now open any of the web browser on to your computer which is connected
with the extender, then on the address bar on the web browser enter your router
default IP address. Then press enter.
6- Now a new login page of your router will open where you have to
enter your router Default username and password.
7- Then you have to Wait for then NETGEAR genie scanning your WiFi
network.
8- Now it will display the available network which is available
within the range of the extender, then you have to select your network and
click Continue.
9- Now you have to enter the password of your main wireless
network and click Continue.
10- Then the name of your wireless network followed by _EXT at the
end.
11-
Once you have connected your wireless devices to the new network then you have
to click on the Finish button to complete the installation and Netgear n300 wifi range extender login.